Configuring Extended-Range Vlans; Default Vlan Configuration - Cisco WS-C3560-48PS-S Software Configuration Manual

Configuring Extended-Range VLANs

To return an interface to its default configuration, use the default interface interface-id interface
configuration command.
This example shows how to configure a port as an access port in VLAN 2:
Switch# configure terminal
Enter configuration commands, one per line.
Switch(config)# interface gigabitethernet0/1
Switch(config-if)# switchport mode access
Switch(config-if)# switchport access vlan 2
Switch(config-if)# end
Configuring Extended-Range VLANs
When the switch is in VTP transparent mode (VTP disabled), you can create extended-range VLANs (in
the range 1006 to 4094). Extended-range VLANs enable service providers to extend their infrastructure
to a greater number of customers. The extended-range VLAN IDs are allowed for any switchport
commands that allow VLAN IDs. You always use config-vlan mode (accessed by entering the vlan
vlan-id global configuration command) to configure extended-range VLANs. The extended range is not
supported in VLAN database configuration mode (accessed by entering the vlan database privileged
EXEC command).
Extended-range VLAN configurations are not stored in the VLAN database, but because VTP mode is
transparent, they are stored in the switch running configuration file, and you can save the configuration
in the startup configuration file by using the copy running-config startup-config privileged EXEC
command.
Note Although the switch supports 4094 VLAN IDs, see the
the actual number of VLANs supported.
This section includes this information about extended-range VLANs:
•
•
•
•

Default VLAN Configuration

See
the MTU size and remote SPAN configuration state on extended-range VLANs; all other characteristics
must remain at the default state.
Catalyst 3560 Switch Software Configuration Guide
12-12
Default VLAN Configuration, page 12-12
Extended-Range VLAN Configuration Guidelines, page 12-13
Creating an Extended-Range VLAN, page 12-14
Creating an Extended-Range VLAN with an Internal VLAN ID, page 12-15
Table 12-2 on page 12-8 for the default configuration for Ethernet VLANs. You can change only
Chapter 12
End with CNTL/Z.
"Supported VLANs" section on page 12-3
Configuring VLANs
for
78-16156-01