Cisco Catalyst WS-C2924-XL Hardware Installation Manual page 85

Catalyst 2900 series xl hardware installation guide
Hide thumbs Also See for Catalyst WS-C2924-XL:
Table of Contents

Advertisement

Chapter 2
Installation
Referring to
Step 2
Note
Connect the other end of the cable to the patch panel or POTS splitter.
Step 3
Each LRE port status LED turns on when it establishes a link with a Cisco LRE
CPE. For more information about the LRE link between the switch LRE port and
the CPE, as well as information about the configuration and management of CPE
devices, refer to the Catalyst 2900 Series XL and Catalyst 3500 Series XL
Software Configuration Guide.
For more information about the Cisco LRE CPE devices, refer to the
Cisco LRE CPE Hardware Installation Guide.
If telephone services, such as voice or ISDN, use the same cabling as LRE traffic,
the LRE port must be connected to the patch panel through a basic telephone
service, also known as plain old telephone service (POTS) splitter. The splitter
routes LRE data (high-frequency) and voice (low-frequency) traffic from the
telephone line to the switch and private branch exchange (PBX) switch or Public
Switched Telephone Network (PSTN).
If the other telephone services are connected through a PBX switch, a
Cisco LRE 48 POTS Splitter can be used. The PBX routes voice traffic to private
telephone networks and the PSTN. For more information about the
Cisco LRE 48 POTS Splitter (PS-1M-LRE-48), refer to the Installation Notes for
the Cisco LRE 48 POTS Splitter.
If the installation does not have a PBX, a homologated POTS splitter is required
to directly connect to the PSTN. For more information about homologated POTS
splitters, contact your Cisco sales representative.
If a connection to a telephone network is not required at all, a splitter is not
Note
needed, and the switch can connect directly to the patch panel.
78-6461-04
Figure
2-30, secure the cable to the switch:
For a 90-degree connector, see the top of
For a 12-degree connector, see the bottom
The cable tie is not included with the connector and cable assembly.
Figure
Figure
Catalyst 2900 Series XL Hardware Installation Guide
Connecting to an LRE Port
2-30.
2-30.
2-41

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents