Storm_Control Messages; Spantree_Fast Messages - Cisco IAD2424-8FXS - IAD 2424 Router System Message Manual

Ethernet access switches
Table of Contents

Advertisement

SPANTREE_FAST Messages

SPANTREE_FAST Messages
This section contains the spanning-tree fast-convergence message.
Error Message SPANTREE_FAST-7-PORT_FWD_UPLINK: [chars] [chars] moved to Forwarding
(UplinkFast).
SPANTREE_VLAN_SW Messages
The section contains the per-VLAN spanning-tree-specific message.
Error Message SPANTREE_VLAN_SW-2-MAX_INSTANCE: Platform limit of [dec] STP instances
exceeded. No instance created for [chars] (port [chars]).

STORM_CONTROL Messages

This section contains the storm control messages.
Error Message STORM_CONTROL-3-FILTERED: A [chars] storm detected on [chars]. A
packet filter action has been applied on the interface.
Cisco ME 3400 and 2400 Ethernet Access Switch System Message Guide
2-66
This message means that the listed interface has been selected as the new path to the
Explanation
root switch for the listed spanning-tree instance. The first [chars] is the spanning-tree instance, and
the second [chars] is the interface.
No action is required.
Recommended Action
This message means that the number of currently active VLAN spanning-tree instances
Explanation
has reached a platform-specific limit. No additional VLAN instances will be created until the
number of existing instances drops below the platform limit. [dec] is the spanning-tree instance
limit, and the first [chars] is the smallest VLAN number of those VLANs that are unable to have
spanning-tree instances created.
Reduce the number of currently active spanning-tree instances by either
Recommended Action
disabling some of the currently active spanning-tree instances or deleting the VLANs associated
with them. You must manually enable the spanning trees that could not be created because of limited
instances.
This message means that the amount of traffic detected on the interface has exceeded
Explanation
the configured threshold values. The system is filtering the excess traffic. The first [chars] is the
traffic type, and the second [chars] is the interface.
Determine and fix the root cause of the excessive traffic on the interface.
Recommended Action
Chapter 2
Messages and Recovery Procedures
OL-9641-01

Advertisement

Table of Contents
loading

Table of Contents