EchoStar DVR-5000 HDD User Manual page 18

Familiarization
Section 4
Fixed dish setup
- Check signal
- Search Channels
Program Satellites
User LNB setting
About EchoStar
System upgrade
Factory reset
F
OR MOTORIZED INSTALLATIONS
System setup
- Autosat (1)
- Autosat (2)
- Search Channels
Fixed dish setup
- Check signal
- Search Channels
Program Satellites
User LNB setting
About EchoStar
System upgrade
Factory reset
Page 4 - 4
I
To select the device that controls the polarity.
I
To set the LNB type(s) you use.
I
Wait for the Checking Configuration to complete.
I
Wait for the search to complete.
I
To set the satellite you want to scan for the LNB.
I
To select a transponder of the selected satellite.
I
To move the dish for best signal level and quality.
I
To select the first or second user defined LNB.
I
To enter the frequencies of the user LNB.
I
To select the device that controls the polarity.
I
To set the control signals.
I
In the About EchoStar information menu you can look
up the factory and receiver information.
I
To select the default or user defined satellite where you
want to download from.
I
Tto reset the receiver to the initial factory settings.
- A
UTOSAT
I
To set the dish type you use.
I
To set the amount of LNBs you have installed.
I
To set the switch type which you use to control the dish
installation (if used).
I
To set the LNB type(s) you use.
I
To set the scan method
I
To set the East and West limits for the dish.
I
To select the reference satellites
I
To move the dish for best signal level and quality.
I
To set the satellites you want to scan for the LNB.
I
Wait for the search to complete.
I
To select the device that controls the polarity.
I
To set the LNB type(s) you use.
I
Wait for the Checking Configuration to complete.
I
Wait for the search to complete.
I
To set the satellite you want to scan for the LNB.
I
To select a transponder of the selected satellite.
I
To move the dish for best signal level and quality.
I
To select the first or second user defined LNB.
I
To enter the frequencies of the user LNB.
I
To select the device that controls the polarity.
I
To set the control signals.
I
In the About EchoStar information menu you can look up
the factory and receiver information.
I
To select the default or user defined satellite where you
want to download from.
I
Tto reset the receiver to the initial factory settings.
EchoStar International Corporation