Replacing The Cover And Powering On The Router - Cisco 7301 Installation And Configuration Manual

Chapter 4 Installing and Removing Field-Replaceable Units

Replacing the Cover and Powering On the Router

The Cisco 7301 router cover fits tightly on the chassis. Follow these instructions to replace the cover:
Figure 4-5
1
Step 1 Holding the cover by the edge with the captive installation screws, tilt the cover and insert the front edge
tabs into their slots under the lip on the top of the router.
Lower the cover, align the captive installation screws with the chassis screw holes, and insert and tighten
Step 2
the three screws with a Phillips screwdriver.
Return the router to its installation site, and attach the grounding cable, and input/output and power
Step 3
cables.
Power on the router by turning the power switch to the on position.
Step 4
OL-5418-07
Inserting the Screws and Replacing the Cover
Inserting the lid under the router lip

Replacing the Cover and Powering On the Router

2
2 Captive installation screws
Cisco 7301 Installation and Configuration Guide
1
4-7