Cisco 7301 Installation And Configuration Manual page 141

Appendix C Configuration Register Information
Setting the Configuration Register While Running ROM Monitor
enable "ignore system config info"? y/n [n]: n
change console baud rate? y/n [n]: n
change the boot characteristics? y/n [n]:y
enter to boot:
0 = ROM Monitor
1 = the boot helper image
2 - 15 = boot system
[0]: 2
Configuration Summary:
enabled are:
load rom after netboot fails
console baud: 9600
boot: image sepcified by the boot system commands or default to: cisco2-c7301
do you wish to change the configuration? y/n [n] n
You must reset or power cycle for new config to take effect
rommon 2 >
Cisco 7301 Installation and Configuration Guide
C-7
OL-5418-07