Cisco 2691 - VPN Bundle Router Hardware Installation Manual page 75

Chapter 3 Installing the Router
Would you like to enter the initial configuration dialog? [yes/no]:
Note
If these messages do not appear, SDM and a default configuration file have been installed on the router
at the factory. To use SDM to configure the router, refer to the quick start guide that shipped with your
router. You can also access the
http://www.cisco.com/univercd/cc/td/doc/product/access/acs_mod/cis2600/26xx_qsg/index.htm
Note
To avoid losing work you have completed, be sure to save your configuration occasionally as you
proceed. Use the copy running-config startup-config command to save the configuration to NVRAM.
Step 1
To proceed with manual configuration using the CLI, enter no:
Would you like to enter the initial configuration dialog? [yes/no]: no
Step 2
Press Return to terminate autoinstall and continue with manual configuration:
Would you like to terminate autoinstall? [yes] Return
Several messages are displayed, ending with a line similar to the following:
...
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled <date> <time> by <person>
Step 3
Press Return to bring up the
...
flashfs[4]: Initialization complete.
Router>
Step 4
Enter privileged EXEC mode:
Router> enable
Router#
For configuration using the CLI, refer to the
Cisco 3600 Series, and Cisco 3700 Series
documentation. You can access these documents on Cisco.com and on the Documentation CD-ROM.
OL-2171-06
Cisco2600 series routers quick start guides
prompt:
Router>
Software Configuration Guide for Cisco 2600 Series,
Routers. or the
Cisco 2600 Series Routers Hardware Installation Guide
Configuring the Router
online at the following URL:
Cisco IOS software configuration
3-29