Inspecting The Router; Tools And Equipment For Installation And Maintenance - Cisco 2691 - VPN Bundle Router Hardware Installation Manual

Inspecting the Router

Inspecting the Router

Do not unpack the router until you are ready to install it. If the final installation site will not be ready
for some time, keep the chassis in its shipping container to prevent accidental damage. When you are
ready to install the router, proceed with unpacking it.
The router, cables, publications, and any optional equipment you ordered may be shipped in more than
one container. When you unpack the containers, check the packing list to ensure that you received all
the following items:
•
•
•
•
•
•
•
•
•
•
•
•
Inspect all items for shipping damage. If anything appears to be damaged, or if you encounter problems
installing or configuring your router, contact customer service. Warranty, service, and support
information is in the quick start guide that shipped with your router.

Tools and Equipment for Installation and Maintenance

You need the following tools and equipment to install and upgrade the router and its components:
•
•
•
•
•
Cisco 2600 Series Routers Hardware Installation Guide
2-6
–
Maintenance schedules and requirements
–
Maintenance procedures performed
–
Intermittent problems
–
Comments and notes
Router
6-foot (1.8-meter) power cord
Rubber feet for desktop mounting (with routers of 1 rack-unit height only)
Rack-mount brackets with screws for 19-inch rack (with all Cisco 2600 series routers)
Rack-mount brackets with screws for 23-inch rack (with Cisco 2691 routers only)
Grounding lug and bracket
RJ-45-to-DB-9 adapter cable for console connection
RJ-45-to-DB-25 adapter cable for modem connection
Ethernet cable
Optional equipment (such as network connection cables or additional rack-mount brackets)
Cisco 2600 Series Modular Routers Quick Start Guide
Cisco 2600 Series, Cisco 3600 Series, and Cisco 3700 Series Regulatory Compliance and Safety
Information document
ESD-preventive cord and wrist strap
Number 2 Phillips screwdriver
Flat-blade screwdrivers: small, 3/16-inch (4-5 mm) and medium, 1/4-inch (5-6 mm)
–
To install or remove modules
–
To remove the cover or mainboard tray, if you are upgrading memory or other components
Rack-mount screws
ROM 32-pin PLCC extractor tool
Chapter 2 Preparing to Install the Router
OL-2171-06