Table of Contents
Advertisement
RX3141 User's Manual
11.3 Setup Date and Time
RX3141 keeps a record of the current date and time, which it uses to calculate and report various data.
However, there is no real time clock inside RX3141; RX3141 relies on external time servers to maintain correct
time. RX3141 allows you to configure up to three external time servers. Make sure that the " Enable " check box
is checked to activate the SNTP (Simple Network Time Protocol) service for time keeping.
Note
The maintain accurate time for the router:
1. Open the Date and Time configuration page, as shown in,Figure 11.3 by double clicking the
Router Setup
2. Select your time zone from the drop-down list.
3. Check the Enable check box to activate the SNTP (Simple Network Time Protocol) service.
4. Enter IP addresses for the SNTP servers that will be used to update the system time.
5. Click on
You can manually enter the correct time, however the time will be reset to the default time, 1/1/2000 00:00:00,
after system is rebooted or powered off.
Changing the date and time on RX3141 does not affect the date
and time on your PCs.
Figure 11.3. Date and Time Configuration Page
Timezone menu.
button to save the settings.
Chapter 11. System Management
73
Advertisement
Table of Contents
