Table of Contents
Advertisement
Chapter 9. Configuring Firewall/NAT Settings
9.3
ACL Rule Configuration Parameters
9.3.1
ACL Rule Configuration Parameters
Table 9.3 describes the configuration parameters firewall inbound, outbound and self-access ACL rules.
Field
ID
Add New
Rule Number
Mave
This option allows you to set a priority for this rule. The RX3141 Firewall acts on packets based on
the priority of the rules. Set a priority by specifying a number for its position in the list of rules:
1 (First)
Other numbers
Action
Allow
Deny
Route to (only for outbound ACL)
This field is used for policy routing needed for PPPoE unnumbered or PPPoE multi-session.
Available options include AUTO, ppp0 (unnumbered), ppp1 (1
session). These options are selectable from the drop-down list. If AUTO is selected, the router will
route the packets based on the information in the routing table.
Log
Select or deselect the check box to enable or disable logging for this ACL rule.
Protocol
This option allows you to select protocol type from a drop-down list. Available settings are All, TCP,
UDP, ICMP, IGMP, AH and ESP.
Source IP
This option allows you to set the source network to which this rule should apply. Use the drop-down
list to select one of the following options:
Any
IP Address
IP Address
52
Table 9.3. ACL Rule Configuration Parameters
Description
Click on this option to add a new ACL rule.
Select a rule from the drop-down list, to modify its settings.
This number marks the highest priority.
Select other numbers to indicate the priority you wish to assign to the rule.
Select this button to configure the rule as an allow rule.
This rule when bound to the Firewall will allow matching packets to pass
through.
Select this button to configure the rule as a deny rule.
This rule when bound to the Firewall will not allow matching packets to
pass through.
This option allows you to apply this rule to all the computers in the source
network, such as those on the Internet for the inbound traffic or all the
computers in the local network for outbound traffic.
This option allows you to specify an IP address on which this rule will be
applied.
Specify the appropriate network address
RX3141 User's Manual
st
PPPoE session), ppp2 (2
nd
PPPoE
Advertisement
Table of Contents
