Advertisement
12. Click Setup, Network and then click Wireless.
13. Click Site Survey. Select an ESSID. The
ESSID (SSID) is the wireless network name
for your wireless network (e.g. wireless router
or access point). If encryption is enabled,
select the proper Authentication and
Encryption type, enter the Pre-Shared Key
and then click Apply. (Example shows
WPA2-PSK. If your wireless network does not
support WPA, select open or shared instead.
Contact your network administrator for more
information).
14. Disconnect the RJ-45 cable and unplug the
power. Then plug the power back in.
15. Verify the Power (Amber) and Link
(Green/Blinking) LEDs are on.
Note:
The TV-IP312WN will not work wirelessly until you disconnect the Ethernet cable from
the back of the camera.
5
Advertisement
