TRENDnet TEW-310APB User Manual page 44

Check and make
sure that the network
adapter is working
properly
3. Resetting the Wireless Access Point to Factory Default Setting.
You may choose to Reset the Wireless Access Point by doing the following:
Ø
Locate the Reset button on the back of the Wireless Access Point
Ø
Use a paper clip to press the Reset button
Ø
Hold the reset button for at least 5 seconds before you release
Ø
Wait till the Wireless Access Point reboots itself (it may take a few minutes), then the
configuration will be set back to factory default values.
4. What are the operation modes supported by the Wireless Access Point?
The Wireless Access Point supports 4 operation modes:
- Access Point:
Forms a wireless network and works as a bridge to communicate with Ethernet LAN network.
- AP Client:
Acts as an wireless client which allows the computers that are connected to the AP to
communicate with other wireless clients.
- Point-to-Point Bridge:
Connects two independent Ethernet LAN networks or computers wirelessly.
- Multi-point Bridge:
Connects more than two independent Ethernet LAN networks or computers wirelessly.
-44-