D-Link DHP-1320 User Manual page 88

Section 3 - Configuration
The DHP-1320's IPv6 Firewall feature allows you to configure which kind of IPv6 traffic is allowed to pass through the device. The DHP-1320's IPv6
Firewall functions in a similar way to the IP Filters feature.
My IPv6 Select PPPoE from the drop-down menu.
Connection:
PPPoE:
Enter the PPPoE account settings supplied by your Internet
provider (ISP).
Address Mode:
Select Static if your ISP assigned you the IP address, subnet
mask, gateway, and DNS server addresses. In most cases, select
Dynamic.
IP Address:
Enter the IP address (Static PPPoE only).
User Name:
Enter your PPPoE user name.
Password:
Enter your PPPoE password and then retype the password in
the next box.
Service Name:
Enter the ISP Service Name (optional).
Reconnection
Select either Always-on, On-Demand, or Manual.
Mode:
MTU: Maximum Transmission Unit - you may need to change the
MTU for optimal performance with your specific ISP. 1500 is
the default MTU.
Maximum Idle
Enter a maximum idle time during which the Internet connection
Time:
is maintained during inactivity. To disable this feature, enable
Auto-reconnect.
D-Link DHP-1320 User Manual
IPv6
PPPoE
83