Table of Contents
Advertisement
DES-3228PA Embedded Web System User Guide
•
Host Timeout — Indicates the amount of time host waits to receive a message before timing out. The default
time is 260 seconds.
•
MRouter Timeout — Indicates the amount of the time the Multicast router waits to receive a message before
it times out. The default value is 300 seconds.
•
Leave Timeout — Indicates the amount of time the host waits, after requesting to leave the IGMP group and
not receiving a Join message from another station, before timing out. If a Leave Timeout occurs, the switch
notifies the Multicast device to stop sending traffic The Leave Timeout value is either user-defined, or an
immediate leave value. The default timeout is 10 seconds.
2.
Check the Enable IGMP Snooping Status checkbox.
3.
Click
. The Multicast Global Parameters Settings Page opens:
Figure 93: Multicast Global Parameters Settings Page
4.
Modify the VLAN ID, IGMP Status Enable, Auto Learn, Host Timeout, MRouter Timeout, and Leave Timeout
fields.
5.
Click
. The IGMP global parameters are sent, and the device is updated.
Page 151
Advertisement
Table of Contents
