Table of Contents
Advertisement
DES-3228PA Embedded Web System User Guide
Defining Default Gateways
Packets are forwarded to the default IP when frames are sent to a remote network via the default gateway. The
configured IP address must belong to the same subnet of one of the IP interfaces. To define a default gateway:
1.
Click Basic Setup > IP Configuration > IP Addressing > Default Gateway. The Default Gateway Page
opens:
Figure 87: Default Gateway Page
The Default Gateway Page contains the following fields:
•
User Defined Default Gateway — Defines the default gateway IP address.
•
Active Default Gateway — Indicates if the default gateway is active. The possible field values are:
•
Remove User Defined — Removes the default gateway. The possible field values are:
–
Checked — Removes the selected default gateway.
–
Unchecked — Maintains the default gateway.
2.
Enter an IP address in the User Defined Default Gateway field.
3.
Click
. The device's default gateway is defined, and the device is updated.
Page 143
Advertisement
Table of Contents
