7-2.4. Ir Remote Id - Clover LCD2284DVR Instruction Manual

System Instruction Manual

7-2.4. IR REMOTE ID

Up to 16 DVR systems can be controlled by only one remote controller we provided, but IDs
should be assigned on each of the systems. You don't have to assign any ID on the single
unit and you can control the system with the provided remote controller without IR REMOTE
ID, which is in the OFF mode (Skip this section).
▫ Click the IR REMOTE ID button and select one among OFF, 1 through 16 to assign an ID
on the system by clicking the mouse.
▫ When an IR Remote ID is assigned on the system, press the "FREEZE" button and the
same channel button on the remote controller as assigned ID on the system to match the
IDs between the system and the remote controller.
When the FREEZE button and the channel button are pressed on the remote controller,
- if the channel button is identical to the assigned ID, the DETECT IR ID as shown in
will be displayed along with the IR ID number.
19]
- if not, the IR ID DENIED as shown in
number.
[Fig.7-18 IR REMOTE ID button]
[Fig.7-20]
[Fig.7-19 DETECT IR ID Message]
[Fig.7-20 IR ID DENIED Message]
82
will be displayed along with the IR ID
[Fig.7-
DVR IR ID
NUMBER
DVR IR ID
NUMBER