5-4.2.1. Connection Of Composite Monitor; 5-4.3. Sensor Connection And Relay In &Out - Clover LCD2284DVR Instruction Manual

System Instruction Manual
- Place the system on the flat surface with soft fabric and set the proper angle of panel
(screen) as shown
- Attach the mounting bracket to the desired location on the wall. Locate wall studs and
securely fix the mounting bracket with the supplied screws.
Note:
- Pay attention to not make scratches or dents on the surface of panel (screen)
during installation of the system.
- In case of this, the warranty will be voided.

5-4.2.1. Connection of Composite Monitor

If necessary, connect the composite Video Output (yellow RCA) and Audio Output (white
RCA) to Video IN and Audio IN on a composite monitor or TV (RCA cable: not included).
5-4.3. Sensor Connection and RELAY IN &OUT
▫ SENSOR Connection (SENSOR IN)
Connect the sensor to ALM (SENSOR) IN. The Sensor should be a contactor type and
support NO (Normal Open).
▫ ALARM OUT Connection
When necessary, use ALARM OUT. The ALARM OUTPUT is a relay contactor type and
supports NO (Normal Open) and NC (Normal Close). The Output capacity is 220V 1A. A
higher capacity can cause system failure.
[Fig.5-3-2].
[Fig 5-4 SENSOR IN PIN]
RS-485
[Fig 5-5]
26