Table of Contents
Advertisement
System Instruction Manual
9-1. HDD (Hard Disk Drive) INSTALLATION
The system manufacturer already installed a 320GB of Hard Disk Drive in the system. Just in
case, refer to the following explanation on how to install a HDD.
▶ The power switch must be turned off before installing and unplug the power cord to prevent
an electric shock that may occur.
▶ Separate the HDD cover by removing two screws on the rear of the system as shown
illustration below.
▶ Set the jumper setting to "Master" position on the HDD. Attach the HDD to the HDD bracket
and install it with four screws as below. Do not securely fix the four screws so that the HDD
moves to the left and the right. Place the HDD with the bracket in its place inside the system.
148
Advertisement
Table of Contents
