Nord Electro 2 Rear Panel; Connections - Clavia Nord Electro 2 User Manual

NORD ELECTRO 2 V3.0x
N E
ORD LECTRO
C
ONNECTIONS
• Make all connections before turning on your power amplifier!
• If you are using a Nord Electro 2 together with a MIDI keyboard, connect a MIDI cable from MIDI
Out on the keyboard to MIDI I
• All signal cables used with the Nord Electro must be shielded.
• The two audio outputs (L
sum of the signals on one separate output only, use R
• If you connect the Nord Electro 2 in stereo to your audio equipment, you should use L
pair with R
IGHT
• If you choose the option to route Organ sounds and Piano sounds to a separate output each (see
"Output routing (hard pan)" on page
O for the Organ sound.
UT
C
ONNECTING PEDALS
The Nord Electro 2 has three pedal inputs, one C
Wah-Wah), one S
slow selection). Connect the pedals as shown in the figure below:
When connecting an expression-type pedal to the C
(Tip-Ring-Sleeve). Please note that the pedal must have a stereo output jack. The resistance range of the
Control Pedal should be 0 to between 10 kOhm and 50 kOhm. Pedals like the Roland EV-5 and control/
expression pedals from Proel works well with the Electro 2. Control/Expression pedals from Yamaha have
different characteristics and are not suitable for use with the Electro 2.
2
REAR PANEL
on the Nord Electro 2.
N
O and R
EFT UT
O .
UT
37), the R
P input (sustain) and one R
USTAIN EDAL
2. Overview: Nord Electro 2 rear panel
O ) are line level and unbalanced. If you want the
IGHT UT
O
IGHT UT
O is for the Piano sound and the L
IGHT UT
P
input (for controlling Organ Swell or
ONTROL EDAL
S
OTOR
P
ONTROL EDAL
.
EFT
input (for rotary speaker fast/
PEED
input, you should use a stereo cable
O in
UT
EFT
Page 9