Key Click Control; Output Routing (Hard Pan) - Clavia Nord Electro 2 User Manual

5. Panel reference: The Organ section
K
EY CLICK CONTROL
On an original B-3 organ, the key click produced by the
random contact bounces is actually an artifact. This arti-
fact later became quite desirable an effect amongst musi-
cians. In the Nord Electro 2 you can select the amount of
key click that should be present in the organ sounds. The
key click level is global for all organ sounds in the Nord
Electro 2.
1. Hold down S
ton twice. The D
stands for 'Click' and '8' for the current click
level.
2. Select key click level by scrolling with the U
D N
OWN AVIGATOR
3. Press any button (except for the S
O
UTPUT ROUTING
If you want to process your sound using external effects,
it can be convenient to route Organ and Piano sounds to
separate outputs of the Nord Electro 2. Note that the
Output routing is not saved, so you will have to re-
configure after power off.
1. Hold down S
ton three times. The D
'H' stands for 'Hard pan' and '0' that both Organ
and Piano sounds are routed to L
R O
IGHT UT
2. Select 'separate outputs' by pressing the U
button so the D
IGATOR
means that Organ sounds will be output only through the L
through the R
mono in 'H.1' mode.
3. Press any button (except for the S
Page 24
and press the P
HIFT ROGRAM
reads 'C.8' where 'C'
ISPLAY
buttons. 'C.0' means minimum key click level and 'C.9' maximum level.
HIFT
(
HARD PAN
and press the P
HIFT ROGRAM
reads 'H.0' where
ISPLAY
EFT
without separation.
reads 'H.1'. 'H.1'
ISPLAY
O . Note that any stereo effect you apply to a sound internally will be in
IGHT UT
HIFT
8 but-
/
P
, S or U /D
TORE P OWN
)
8 but-
O and
UT
N -
P AV
EFT
, S or U /D
TORE P OWN
NORD ELECTRO 2 V3.0x
buttons) to exit.
O and Piano sounds only
UT
buttons) to exit.