Midi Functions; About The Midi Implementation; Note On/Off; Pitch Bend - Clavia Nord Electro 2 User Manual

NORD ELECTRO 2 V3.0x
7. MIDI
A
BOUT THE
The following MIDI messages can be transmitted and received from Nord Electro 2:
N O /O
OTE N FF
• Note On and Note Off messages are of course transmitted when you play the keyboard. If you use
the O S
CTAVE HIFT
keyboard ± 2 octaves (if the selected instrument supports this).
• Notes can be received over the entire MIDI Note range. However, due to the actual note range of
the controlled instrument type, there will be silent notes when exceeding their ranges.
P B
ITCH END
• Pitch Bend messages are neither transmitted nor recognized by the Nord Electro 2.
C
ONTROLLERS
• If you have an Control/Expression pedal connected to the C
mitted and received as Controller 11 (Expression).
• If you have a sustain pedal connected to the S
received as Controller 64 (Sustain Pedal).
• If you have a sustain pedal connected to the R
as Controller 82.
• All other controls (knobs and buttons) on the front panel (except M
mitted and received as Control Change messages. This can be used to record your actions on the
front panel into a MIDI sequencer. For a full list of which parameters correspond to which Con-
troller number, see the MIDI implementation chapter on
K V
EYBOARD
Nord Electro 2 can transmit and receive Keyboard Velocity messages. Note that incoming Keyboard
Velocity data is ignored when in Organ mode. Organ sounds will always be played back at nom-
inal level regardless of incoming MIDI Velocity data.
P C
ROGRAM HANGE
When you select a Program, a Program Change message is transmitted via MIDI on the selected MIDI
Channel. If a Program Change message is received on the selected MIDI Channel, Nord Electro 2 will
change Program accordingly. The 48 Program locations send and respond to Program Change values 0-47
where 0 is Program A1 and 47 is Program F8.
FUNCTIONS
MIDI
IMPLEMENTATION
function (see "Octave Shift" on page
ELOCITY
7. MIDI functions: About the MIDI implementation
33), you can transpose the Nord Electro 2
ONTROL
P I
USTAIN EDAL NPUT
S I
OTOR PEED NPUT
page 45.
P I , this is trans-
EDAL NPUT
, this is transmitted and
, this is transmitted and received
L ), are also trans-
ASTER EVEL
Page 41