Pppoa Settings; Mobile Network - Cisco SRP521W Administration Manual

Setting up the Interfaces of the Services Ready Platform
Setting up the WAN Interface
STEP 1
STEP 2
STEP 3
Services Ready Platform SRP 500 Series Administration Guide

PPPoA Settings

Field
User name and
Password
Connect on
Demand
Keep Alive

Mobile Network

You can configure your Services Ready Platform to connect to a 3G USB modem
that is connected to its USB interface. Refer to
more details on compatible 3G USB modem devices.
The Services Ready Platform allows you to set the connect mode. You can
configure an automatic or manual connection. You also can use this page to view
the current connection status.
Click Interface Setup on the tab and then click Mobile Network in the navigation
pane. The Mobile Network page appears.
If necessary, change any global settings in the Global Settings area. The Card
Status field shows the status of your mobile card.
If necessary, change any mobile network settings in the Mobile Network Setup
area.
Description
Enter the strings that your ISP has instructed you to use.
The user name may be called a "username," "login
name," or "login."
Click this option if you want your broadband gateway to
connect to your ISP when a connection is needed, and
to disconnect when the line to your ISP has been idle for
a given amount of time. Connection and disconnection
are automatic. You can also adjust the maximum idle
time; the default setting is 20 minutes. The alternative to
Connect on Demand is Keep Alive (see next). In most
cases you can choose either option without consulting
your ISP.
Click this option if you want the gateway to maintain the
connnection to your ISP all the time. If the link goes
down for a given number of seconds (the "redial
period"), the gateway will automatically try to re-
establish it. The default redial period is 20 seconds.
www.cisco.com/go/srp500
4
for
46