Motorola HT-1000 Service Manual page 55

Unit with
Large Tabs
early Front Shield
Control
Top
Recessed
PTT Switch
Area for
Area
Prying Loose
NOTE: A large portion of the controls flex is attached to the
large metal shield (front shield) with adhesive. Do not
remove the controls flex from the front shield.
9. As a unit, separate the control top, the front shield, and the
controls flex from the chassis and circuit boards (see Figure 8).
NOTE: Three locking clips (four tabs on early front shield)
secure the front shield to the chassis and hold the RF
board and the controller board in the chassis.
Four (4)
Controls
Front Flex
Shield
MAEPF-22574-A
Figure 8 Separating Control Top From the Chassis
a. Loosen the front shield by prying each of the three clips (four
tabs on early front shield) away from the chassis. Be careful
not to pry the clips/tabs any more than is necessary to free
them from their respective retaining slots. To completely
loosen the shield from the chassis, a slight lifting and
clockwise twisting action may be required.
b. Insert a small, flat-blade screwdriver in the recessed area of
the control top and pry the control top slightly away from the
chassis.
c. Completely remove the control top/front shield/controls flex
unit from the chassis.
10.Carefully remove the RF board and the controller board from the
chassis.
Three (3)
Unit with
Locking Clips
latest Front Shield
Control
Top
Recessed
PTT Switch
Area for
Area
Prying Loose
Controls
Front
Flex
Shield
MAEPF-27017-O
33