Table 6 Test Frequencies, Ht 1000 / Jt 1000 - Motorola HT-1000 Service Manual

NO. OF TEST
BEEPS CHANNEL
TX #1
1
RX #1
TX #2
2
RX #2
TX #3
3
RX #3
TX #4
4
RX #4
TX #5
5
RX #5
TX #6
6
RX #6
Control Head Test Mode,
HT 1000/JT 1000 Radios

Table 6 Test Frequencies, HT 1000 / JT 1000

VHF UHF BAND 1
136.025 403.100
136.075 403.150
142.125 424.850
142.175 424.900
154.225 438.050
154.275 438.100
160.125 444.050
160.175 444.100
168.075 456.350
168.125 456.400
173.975 463.700
173.925 463.650
To check the buttons and the switches, perform the following tests:
1. Turn radio on.
2. After the self test is complete, press the monitor button (side
button 3, SB3) five times in succession, within 10 seconds. After
the fifth press, a tone is emitted to indicate that the RF test mode
has been entered.
3. Exit the RF test mode and enter the control head test mode by
pressing and holding SB3 for more than three seconds. Upon
entering the control head test mode, a tone is emitted and the
green LED begins flashing. The green LED continues to flash until
the control head test mode is exited.
NOTE: Return to the RF test mode by pressing and
holding SB3 for more than three seconds. Then
re-enter the control head test mode by pressing
and holding SB3 for more than three seconds.
4. Test each switch (toggle, rotary, or button-actuated) by changing
the position of the switch. A tone is emitted to indicate a "good
test" each time a switch position is changed.
NOTE: Pressing and releasing a button-actuated
switch are both considered switch-position
changes.
NOTE: No tone when a switch position is changed
indicates a test failure. Test the on/off volume
potentiometer/switch by rotating the
potentiometer clockwise and counter
UHF BAND 2
450.025 806.0125
450.075 851.0625
465.225 815.0125
465.275 860.0625
475.225 824.9875
475.275 869.9375
484.975 851.0125
485.025 851.0625
500.275 860.0125
500.325 860.0625
511.975 869.9875
511.925 869.9375
800
9