Manual Tuning; Stations - Aiwa XR-MD90 Operating Instructions Manual

MANUAL TUNING
TUNER/
BAND
TUIN ER/
BAND
.4+ , >
MODE TUNER
TUNERI
BAND
1 Press the TUNER/BAND button repeatedly to
select the desired band.
m
If the power is turned off, the previously
played (Direct Play Function).
2 Press the ++ or > button to
tuned station will be
select a station.
Each time the button is pressed, the frequency changes.
When a station is received, "TUNE" is displayed for a moment.
During FM stereo reception, (lI@Ill is displayed.
When an
FM stereo broadcast contains noise
Press the MODE TUNER button while pressing the SHIFT button
on the remote control.
"MONO" appears on the display.
Noise is reduced, although reception is monaural.
To restore stereo reception, repeat the above again
To change the AM tuning interval
The default setting of the AM tuning interval is 10 kHz/step. If
you use this unit in an area where the frequency allocation system
is 9 kHz/step, change the tuning interval.
Press the POWER button while pressing the TUNER/BAND
button.
To reset the interval, repeat this procedure.
m
When the AM tuning interval is changed, all preset stations (see
"PRESETTING STATIONS") are cleared. The preset stations
have to be set again.
TO ~ear~h
for a station
quickly
(Auto Search)
Keep the <+ or > button pressed until the tuner starts
searching for a station. After tuning in to a station, the search
stops.
To stop the Auto Search manually, press the ++ or ~- button.
o The Auto Search may not stop at stations with very weak
signals.
ENGLISH
9