Table of Contents
Advertisement
Letie mae
old Pea
A.
Bae
1
38
MONO
TUNER
RADIO RECEPTION
MANUAL TUNING
amb
Press the TUNER/BAND buiton to select the band.
You can also select the tuner by pressing the TUNER/BAND
button with the power off. After the power comes on, press it
again as follows to select the band.
Sih
aia
Press the << DOWN or »» UP button to select a
station.
nh
Each time it is pressed, the frequency changes.
When a station is received, TUNE is displayed for 2 seconds.
During FM stereo reception, ({(@))) is displayed.
To search for a station quickly (Auto search)
Keep the << DOWN or
UP button pressed until the tuner
starts searching for a station.
After tuning in to a station, the
search stops.
The search may not stop at stations with very weak signals.
When an FM stereo broadcast is noisy
Press the MONO TUNER buiton on the remote control to display
MONO. — FY
Background noise is reduced, though reception is monaural.
To restore stereo reception, press the MONO TUNER button again
to extinguish MONO.
To change the MW tuning interval
The MW tuning interval is factory-set to 9 kHz.
If you use this unit in an area where the frequency allocation system
is 10 kHz, change the MW tuning interval.
With the TUNER function selected, press the POWER button while
pressing the TUNER/BAND button. To reset the interval, repeat
this procedure.
NOTE)
When the MW tuning interval is changed, all preset stations (see
page 40) are cleared.
The preset stations have to be set again.
Advertisement
Table of Contents
