Configuring Radius Protocol - 3Com 8807 Configuration Manual

Configuring RADIUS
Protocol
By default, the integer mode is used. That is, the switch supports the RADIUS
server delivering VLAN IDs in integer form.
Configuring name of a delivered VLAN
Perform the following configuration in VLAN view.
Table 206 Configure the name of a delivered VLAN
Operation
Configure the name of a delivered VLAN
Remove the configured VLAN name and restore it to the default name
By default, the delivered VLAN does not have a name.
For the 3Com Series Switches, the RADIUS protocol is configured on the per
RADIUS scheme basis. In real networking environment, a RADIUS scheme can be
an independent RADIUS server or a set of primary/secondary RADIUS servers with
the same configuration but two different IP addresses. Accordingly, attributes of
every RADIUS scheme include IP addresses of primary and secondary servers,
shared key and RADIUS server type etc.
Actually, RADIUS protocol configuration only defines some necessary parameters
using for information interaction between NAS and RADIUS Server. To make these
parameters take effect on an ISP domain, you must configure the ISP domain to
use the RADIUS scheme configured with these parameters in ISP domain view. For
more about the configuration commands, refer to the AAA Configuration section
above.
The following sections describe RADIUS protocol configuration tasks.
"Creating/Deleting a RADIUS scheme"
■
"Setting IP Address and Port Number of a RADIUS Server"
■
"Setting the RADIUS Packet Encryption Key"
■
"Configuring VPN of RADIUS Server"
■
"Setting the Port State of the Local RADIUS Server"
■
"Setting the Maximum Retry Times for RADIUS Request Packets"
■
"Setting RADIUS Server Response Timeout Timer"
■
"Setting Quiet Time of RADIUS Server"
■
"Setting the Retransmission Times of RADIUS Request Packets"
■
"Enabling the Selection of Radius Accounting Option"
■
"Setting a Real-time Accounting Interval"
■
"Setting the Maximum Times of Real-time Accounting Request Failing to be
■
Responded"
"Enabling/Disabling Stopping Accounting Request Buffer"
■
"Setting the Maximum Retransmitting Times of Stopping Accounting Request"
■
"Setting the Supported Type of RADIUS Server"
■
"Setting RADIUS Server State"
■

Configuring RADIUS Protocol

Command
name string
undo name
245