Displaying And Debugging Link Aggregation; Link Aggregation Configuration Example - 3Com 8807 Configuration Manual

108 C 14: L A
HAPTER INK
Displaying and
Debugging Link
Aggregation
Link Aggregation
Configuration
Example
C
GGREGATION ONFIGURATION
Table 92 Configuring port priority
Operation
Configure port priority
Restore the default port priority
By default, port priority is 32,768.
After the above configuration, execute the display command in any view to
display the running of the link aggregation configuration, and to verify the effect
of the configuration.
In user view, execute the reset command to clear statistics on the LACP-enabled
port, and the debugging command to enable LACP debugging.
Table 93 Displaying and debugging link aggregation
Operation
Display summary information of all
aggregation groups
Display detailed information of a specific
aggregation group
Display the local device ID
Display detailed link aggregation information
at the port
Clear LACP statistics on the port
Disable/enable LACP state debugging
Disable/enable LACP packet debugging
Disable/enable link aggregation error
debugging
Disable/enable link aggregation event
debugging
Network requirements
Switch A connects switch B with three aggregation ports, numbered as
Ethernet2/1/1 to Ethernet2/1/3, so that incoming/outgoing load can be balanced
among the member ports.
Command
lacp port-priority port-priority-value
undo lacp port-priority
Command
display link-aggregation summary
display link-aggregation verbose [ agg-id ]
display lacp system-id
display link-aggregation interface
interface-type interface-number [ to
interface-type interface-number ]
reset lacp statistics [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
[ undo ] debugging lacp state [ interface
interface-type interface-number [ to
interface-type interface-number ] ] { {
actor-churn | mux | partner-churn | ptx | rx
}* | all }
[ undo ] debugging lacp packet [ interface
interface-type interface-number [ to
interface-type interface-number ] ]
[ undo ] debugging link-aggregation error
[ undo ] debugging link-aggregation
event