10 - 2 Symbol LS2208 Product Reference Guide
Connecting Using Undecoded Scanner Emulation
To perform undecoded scanner emulation, connect the scanner to a portable data terminal, or a controller which
collects the data and interprets it for the host.
Undecoded Scanner Emulation Connection
Figure 10-1
Connect the undecoded interface cable to the bottom of the scanner, as described in
1.
Cable on page
Connect the other end of the interface cable to the scanner port on the portable data terminal or controller.
2.
Scan the appropriate bar codes in this chapter to configure the scanner.
3.
CAUTION
1-3.
Connect the scanner to 5 volt decoders only. Connecting the scanner to a 12 volt decoder invalidates
the warranty.
Host Port Connector
Interface cable
Installing the Interface