Serial Port Settings; Mac Notification - D-Link DES-3250TG User Manual

Serial Port Settings

The configure the serial port settings, open the configuration menu and click on the Serial Port Settings link. This window is
used to configure the console settings for the Command Line Interface or for a Telnet session.
The Serial Port Settings window is used to change and view the Console settings for your switch. The default Baud Rate for
this switch is set at 9600 and may be altered from 119200, 38400, to 115200 to perform different functions. The Data Bits (8),
Parity Bits (none) and Stop Bits (1) are read only fields and cannot be changed using the web-based manager. The Auto
Logout field may be set to Never, 2 minutes, 5 minutes, 10 minutes, and 15 minutes, depending on the time the user wishes
the Switch to be idle before automatically logging out. The default for this setting is 10 minutes.

MAC Notification

MAC Notification is used to monitor MAC addresses learned and entered into the forwarding database. To globally set MAC
addresses on the Switch, 0pen the following screen by clicking MAC Notification on the Configuration menu.
D-Link DES-3250TG Standalone Layer 2 Switch
RMON Status
<Disabled>
802.1x Status
Asymetric VLAN
<Disabled>
Syslog Global State
<Disabled>
Figure 7- 4. Serial Port Settings window
Destination, or Mac Source.
To enable RMON capability, toggle Disabled
to Enabled.
To enable 802.1x port control access on a
global basis, toggle Disabled to Enabled.
To enable Asymetric VLANs, toggle to
Enabled. Please note that when the user sets
Asymetric VLANs to Disabled, then the
factory default VLAN setting is restored.
To enable Syslog Global State, toggle to
Enabled.
35