Snmp Settings - D-Link DES-3250TG User Manual

D-link stackable layer 2 switch user's guide
Hide thumbs Also See for DES-3250TG:
Table of Contents

Advertisement

After your initial login, define new passwords for both default user names to prevent unauthorized access to the Switch, and
record the passwords for future reference.
To create an administrator-level account for the Switch, do the following:
At the CLI login prompt, enter create account admin followed by the <user name> and press the Enter key.
You will be asked to provide a password. Type the <password> used for the administrator account being created and
press the Enter key.
You will be prompted to enter the same password again to verify it. Type the same password and press the Enter
key.
Successful creation of the new administrator account will be verified by a Success message.
The sample below illustrates a successful creation of a new administrator-level account with the user name "newmanager".

SNMP Settings

Simple Network Management Protocol (SNMP) is an OSI Layer 7 (Application Layer) designed specifically for managing and
monitoring network devices. SNMP enables network management stations to read and modify the settings of gateways, routers,
switches, and other network devices. Use SNMP to configure system features for proper operation, monitor performance and
detect potential problems in the Switch, switch group or network.
Managed devices that support SNMP include software (referred to as an agent), which runs locally on the device. A defined set
of variables (managed objects) is maintained by the SNMP agent and used to manage the device. These objects are defined in a
Management Information Base (MIB), which provides a standard presentation of the information controlled by the on-board
D-Link DES-3250TG Standalone Layer 2 Switch
NOTE: Passwords are case sensitive. User names and passwords can be up to
15 characters in length.
Figure 5- 4 Creation of a new Admin level account
NOTICE: CLI configuration commands only modify the running
configuration file and are not saved when the Switch is rebooted. To
save all your configuration changes in nonvolatile storage, you must
use the save command to copy the running configuration file to the
startup configuration.
21

Advertisement

Table of Contents

Troubleshooting

loading

Table of Contents

Save Article as PDF