D-Link DSL-G804V User Manual page 27

PPPoE - Advanced Options:
Parameter
LLC Header
Create Route
Specific Route
Subnet Mask
Route Mask
MRU
Discover Primary /
Secondary DNS
Give DNS to Relay
Give DNS to Client
Give DNS to DHCP
Server
Discover Primary
NBNS / Discover
Secondary NBNS
Discover Subnet
Mask
Give Subnet Mask
To DHCP Server
DSL-G804V Wireless ADSL Router User's Guide
Description
Selects encapsulation mode, true for using LLC or false for using VC-Mux.
This setting specifies whether a route is added to the system after IPCP
(Internet Protocol Control Protocol) negotiation is completed. If set to enabled,
a route will be created which directs packets to the remote end of the PPP link.
Specifies whether the route created when a PPP link comes up is a specific or
default route. If set to enabled, the route created will only apply to packets for
the subnet at the remote end of the PPP link. The address of this subnet is
obtained during IPCP negotiation.
Sets the subnet mask used for the local IP interface connected to the PPP
transport. If the value 0.0.0.0 is supplied, the netmask will be calculated from
the class of the IP address obtained during IPCP negotiation.
Sets the subnet mask used by the route that is created when a PPP link
comes up. If it is set to 0.0.0.0, the subnet mask is determined by the IP
address of the remote end of the link. The class of the IP address is obtained
during IPCP (Internet Protocol Control Protocol) negotiation.
Maximum Receive Unit. This is negotiated during the LCP protocol stage.
This setting enables/disables whether the primary/secondary DNS server
address is requested from a remote PPP peer using IPCP. The default setting
for this command is enabled.
Controls whether the PPP Internet Protocol Control Protocol (IPCP) can
request the DNS server IP address for a remote PPP peer. Once IPCP has
discovered the DNS server IP address, it automatically gives the address to
the local DNS relay so that a connection can be established.
Controls whether the PPP Internet Protocol Control Protocol (IPCP) can
request a DNS server IP address for a remote PPP peer. Once IPCP has
discovered the DNS server IP address, it automatically gives the address to
the local DNS client so that a connection can be established.
Similar to the above, but gives the DNS server address to the DHCP server.
This setting enables/disables whether the primary/secondary NBNS server
address is requested from a remote PPP peer using IPCP. The default setting
for this command is disabled.
Specifies if the subnet mask given by IPCP negotiation process is to be used
Enable to change your DHCP Server settings by using the given information in
IPCP negotiation process.
19