Table of Contents
Advertisement
DI-206 ISDN Remote Router
Connection Test – Position the cursor over this item and press <Enter> to begin
the test. The router will dial the phone number defined above, try to establish a
valid link with the answering ISDN device and hang up. This test can only be
performed if the Interface is disabled in the Interface Configuration, ISDN
submenu.
Dial Out – Press <Enter> to begin the test. The router will dial the phone number
above and negotiate a connection with the answering device. In order for this test
to work, a Remote Network Profile must be created for the connection.
Hang up – Press <Enter> to hang up after Dialing Out.
Ping Test
This test makes sure there is an IP network connection to a particular IP address.
The parameters are described as follows:
IP Address – This is the IP Address of the device that the router will attempt to
reach. The router will check it routing table and try to locate the IP Address.
Count – The number of pings (packets) that will be sent. A value of 0 will cause
pings to be sent continuously.
Delay (10ms) – The amount of time in 10 millisecond intervals between each
ping in the Count.
Start Ping Test - Press <Enter> or <Return> to begin the test.
Loopback Test
The loopback test is used to test the path ISDN network between your phone
company's switch and the router.
78
Advertisement
Table of Contents
