Table of Contents
Advertisement
DI-206 ISDN Remote Router
1. The LAN port must be enabled in the Interface Configuration sub-menu.
2. Enable IP Networking
3. Assign an IP address to the LAN port in the Network Configuration sub-menu
of the Main Menu.
4. Enable the Telnet/Discovery function on the router.
Choose Interface Configuration, LAN.
Position the cursor over the State item and press <space bar>. The State will
change from Disable to Enable.
Position the cursor on the SAVE option at the bottom of the screen and press
<Enter> to save the new setting.
Choose Exit in the sub-menus to return to the Main Menu.
Choose Network Configuration, IP Configuration.
Position the cursor over the third item IP Networking and press <space
bar> to Enable it.
Position the cursor on the Save option at the bottom of the screen and press
<Enter> to save the new setting.
Still in Network Configuration, IP Configuration submenu from Step 2
above, choose IP Stack Configuration, LAN.
Enter a valid IP address for the LAN in the first item. You may also enter a
Netmask if you wish. For more information about IP Addresses and Subnet
masks, please refer to Appendix B, "IP Concepts."
Position the cursor on the Save option at the bottom of the screen and press
<Enter> to save the new setting.
Choose EXIT in the sub-menus to return to the Main Menu.
From the Main Menu choose Advanced Functions.
Choose the Telnet/Discovery Enable option and then Enable Telnet State.
Position the cursor on the Save option at the bottom of the screen and press
<Enter> to save the new settings.
Choose Exit in the sub-menus to return to the Main Menu.
14
Advertisement
Table of Contents
