When An Error Message Is Displayed During Measurement; When A Warning Message Is Displayed After Measurement - Yamaha RX-V665 Owner's Manual

When an error message is displayed
during measurement
Select "Retry" or "Exit" using oCursor l / h
and then press oENTER.
ERROR
.
E-9:USER CANCEL
Don't operate
any function
>Retry
p [
[ ]/[ ]:Select
[ENTER]:Return
Retry
Performs "Auto Setup" again.
Exit
Terminates the measurement and "Auto Setup."
y
• See page 69 for details on error messages.
• When "E-5:NOISY" appears, you can continue measurement. To
continue measurement, select "Proceed." However, we recommend that
you solve the problem first and then perform measurement again.
Exit
Optimizing the speaker setting for your listening room (YPAO)
When a warning message is displayed
after measurement
If a problem occurs during measurement, "WARNING" is
displayed on the result display screen. Check the error and
solve the problems.
WARNING
W-1:OUT OF PHASE
Reverse channel
FL
CENTER
SL
SBL
p [
[ ]/[ ]:Select
[ENTER]:Return
y
• See page 70 for details on warning messages.
• Optimization will not be performed while a warning message is
displayed. We recommend that you solve the problem and perform "Auto
Setup" again.
1
Check if "→" is displayed on the left of
"WARNING" and press oENTER.
Details of the warning message are displayed. If there
are multiple warning messages, you can display the
next message using oCursor h.
2
To return to the top result display, press
oENTER again.
---
---
---
21
En