Xm Satellite Radio (U.s.a. Model Only) - Yamaha RX-V665 Owner's Manual

Problem
The desired station
cannot be tuned into
with the automatic
tuning method.
There are continuous
crackling and hissing
AM
noises.
There are buzzing and
whining noises.

XM Satellite Radio (U.S.A. model only)

If an operation takes longer than usual or an error occurs, one of the following messages may appear on the front panel
display. In this case, read the cause and follow the corresponding remedies.
Status message
CHECK XM TUNER
The XM Mini-Tuner is not installed in the
XM Mini-Tuner Home Dock or the XM
Mini-Tuner Home Dock is not connected
to this unit.
CHECK ANTENNA
The XM antenna is not connected to the
XM Mini-Tuner Home Dock or the XM
antenna cable has become damaged.
LOADING XM
The XM Mini-Tuner is acquiring audio or
program information from the XM
satellite signal. This message can also
occur in weak XM signal conditions. Note
that this unit may not respond to some
operations while this message is
displayed.
NO SIGNAL
The XM Mini-Tuner is not receiving the
XM satellite signal. Something may be
blocking the XM antenna's view of the
satellites or the antenna is not properly
aimed.
CH OFF AIR
The XM channel you selected is not
currently broadcasting.
CH UNAUTH
You may be attempting to tune to an XM
channel that is blocked or that you cannot
receive with your XM subscription
package.
Cause
The signal is weak or the antenna
connections are loose.
Supplied AM loop antenna is not
connected.
The noises may be caused by lightning,
fluorescent lamps, motors, thermostats
and other electrical equipment.
A TV set is being used nearby.
Cause
Remedy
Adjust the AM loop antenna orientation.
Use the manual tuning method.
Connect the AM loop antenna correctly even
if you use an outdoor antenna.
It is difficult to completely eliminate noise,
but it can be reduced by installing and
properly grounding an outdoor AM antenna.
Move this unit away from the TV set.
Remedy
Confirm the XM Mini-Tuner is fully seated in the
dock and check the XM Mini-Tuner Home Dock
cable is connected to this unit.
Check that the XM antenna is securely connected to
the XM Mini-Tuner Home Dock and check the
antenna cable for damage. Replace the XM antenna if
the cable is damaged.
This message should disappear in a few seconds in
good signal conditions. If you see this message often,
reposition the XM antenna to get better signal
reception. Use the "ANTENNA INFO" information
on the front panel display or "XM Information"
screen in the video monitor to check the antenna
reception level.
Check for antenna obstructions and reposition the
XM antenna to get better signal reception. Use the
"ANTENNA INFO" information on the front panel
display or "XM Information" screen in the video
monitor to check the antenna reception level. See
instructions supplied with the XM Mini-Tuner and
Dock for antenna installation information.
Check back at a later time; in the meantime, select
another channel.
Consult the latest channel guide at
http://www.xmradio.com/ for the current list of
channels. For information on receiving this channel,
visit http://www.xmradio.com/ or contact XM
Satellite Radio at 1-800-967-2346.
Troubleshooting
See
page
18
29
18
18
—
See
page
31
31
34
34
—
31
65
En