Yamaha HTR-6050 Owner's Manual page 31

■ If an error screen appears
Press G k / n / l / h to select "RETRY" or
"EXIT" and then press G ENTER.
The following display is an example where "E-5:USER
CANCEL" appears in the OSD.
AUTO:ERROR
. E-5:USER CANCEL
Don't operate
any function
>
RETRY
[ ]/[ ]:Select
[ENTER]:Return
Choices: RETRY, EXIT
• Select "RETRY" to retry the "AUTO SETUP"
procedure.
• Select "EXIT" to exit from the "AUTO SETUP"
procedure.
EXIT
Optimizing the speaker setting for your listening room
■ If "WARNING" appears
When this unit detects potential problems during the
"AUTO SETUP" procedure, "WARNING" appears in the
"RESULT:EXIT" display. Check the warning messages to
correct your speaker settings.
Note
Warnings differ from errors in that warnings do not cancel the
"AUTO SETUP" procedure.
1
Make sure the pointer is pointing at
"WARNING" and then press G ENTER to
display the detailed information about the
warning.
The number on the right of "WARNING" indicates
the number of warning messages.
AUTO:RESULT
. WARNING(1)
RESULT
SP
DIST:
LVL :
>
SET
[ ]/[ ]:Up/Down
[ENTER]:Enter
2
Press Gl / h repeatedly to toggle between
the warning displays.
WARNING:W-1
<OUT OF PHASE>
Reverse Channel
--
CENTER
--
[p]/[[]:Select
[ENTER]:Return
y
• For details about each warning message, see the "AUTO
SETUP" section in "Troubleshooting" on page 65.
• When the corresponding warning message is not
applicable to a speaker, "– –" is displayed instead.
Press G ENTER to return to the top
3
"RESULT:EXIT" display.
: 3/2/0.1
3.2/3.5m
-2/+2dB
CANCEL
FR
--
27
En