Repairing A Torn Ribbon - Kodak 1400 User Manual

Repairing a Torn Ribbon

1. Position the ribbon carrier with the torn ribbon on a clean place as shown
below.
Transparent tape
2. Place a piece of transparent tape on the center of the ribbon.
3. Wind the takeup spool counterclockwise so that the tape is not seen and
the ribbon is straight.
4. Install the ribbon carrier in the 1400 printer.
CONTENTS
PRINTER DRIVER GUIDE
Supply spool
Takeup spool
HELP
SEARCH
Introduction
Setting up the 1400
Printer
Operating the 1400
Printer
Troubleshooting
Site Specifications
Accessories and
Supplies