ASROCK ALIVEN570SLI-ESATA2 User Manual page 27

ATX 12V Power Connector
(4-pin ATX12V1)
(see p.11, No. 3)
SLI/XFIRE Power Connector
(4-pin SLI/XFIRE_PWR1)
(see p.11 No. 36)
IEEE 1394 Header
(9-pin FRONT_1394)
(see p.11 No. 24)
HDMI_SPDIF Header
(3-pin HDMI_SPDIF1)
(see p.11, No. 27)
HDMI_SPDIF Cable
(Optional)
A. black end
+5V
SPDIFOUT
blue
GND black
Please note that it is necessary
to connect a power supply with
ATX 12V plug to this connector.
Failing to do so will cause power
up failure.
It is not necessary to use this
connector, but please connect it
with a hard disk power connecor
when two graphics cards are
SLI/XFIRE_POWER1
plugged to this motherboard at
the same time.
Besides one default IEEE 1394
RXTPAM_0
GND
RXTPBM_0 port on the I/O panel, there is one
+12V
GND
IEEE 1394 header
1
(FRONT_1394) on this
+12V
RXTPBP_0
motherboard. This IEEE 1394
GND
RXTPAP_0
header can support one IEEE
1394 port.
HDMI_SPDIF header, providing
SPDIF audio output to HDMI VGA
1
card, allows the system to
GND
SPDIFOUT
+5V
connect HDMI Digital TV/
projector/LCD devices. Please
connect the HDMI_SPDIF
connector of HDMI VGA card to
this header.
Please connect the black end (A)
of HDMI_SPDIF cable to the
C
HDMI_SPDIF header on the
B
motherboard. Then connect the
A
white end (B or C) of
HDMI_SPDIF cable to the
HDMI_SPDIF connector of HDMI
VGA card.
B. white end (2-pin) C. white end (3-pin)
SPDIFOUT
blue
GND black
2 7 2 7 2 7 2 7 2 7
SPDIFOUT
blue
GND black