Table of Contents
Advertisement
Installation Requirements
2-1
Installation Requirements
2-2
CX-Profibus
2-2-1
Starting CX-Profibus
Starting CX-Profibus
Login Window
Default Password
!Caution If access limitation to CX-Profibus is required by the application, the password
Generating the Device
Catalogue
16
CX-Profibus Configuration software is required to configure the PROFIBUS
Master before operating the network. Without a valid configuration the
PROFIBUS Master Unit will not be able to achieve data communication with
the slave devices on the network.
The following are the minimum requirements for a PC to install the CX-Profi-
bus configurator software:
• PC Pentium III or higher, 500 MHz minimum
• Operating System:
• RAM:
• Hard disk space:
• Graphics resolution:
• Serial port:
• CD-ROM drive
• Communication cable: Cable CS1W-CN226 to connect to the peripheral
port on the CPU (Not included with CX-Profibus)
Select Program, OMRON, and CX-Profibus, from the Start Menu if the
default program folder name is used.
At startup, the CX-Profibus splash screen will appear, on top of which a login
window as shown below will be displayed.
The Login window provides the selection of the access level as well as the
entry of the password belonging to the access level selected.
The default password at the first start up of CX-Profibus is "password" and is
applicable to all access levels. Type in "password" (without the quotes) at the
password entry line and select OK.
should be changed as soon as possible. Changing passwords is only possible
on the Administrator level. Refer to Changing the Passwords for an explana-
tion on how to change passwords.
After entering the correct password, CX-Profibus will start up and open. The
first time CX-Profibus is started, the Device Catalogue will still be empty.
Windows 2000 SP2 / Windows NT 4.0, SP6 /
Windows XP
256 MB minimum
256 MB minimum
1024 x 768 pixels minimum
RS-232C; COM1 to COM4 supported
Section 2-1
Advertisement
Chapters
Table of Contents
Troubleshooting
