Omron WS02-9094G - V1.0 Operation Manual page 44

CS1/CJ1W-PRM21 PROFIBUS Master DTM
Master DTM Configuration
User Interface
Configuration Interface
Buttons
Note The Configuration User Interface for each of the two CS1/CJ1 PROFIBUS
Master DTMs contains the same views and setting options.
The Master DTM Configuration User Interface contains four tabs:
• Device Setup tab
• Master Setup tab
• Bus Parameters tab
• Slave Area tab
The four tabs are discussed below.
The Master DTM Configuration User Interface contains four general buttons.
They are listed in the table below, together with the action taken when press-
ing them.
Button
OK Evaluate, and save the changes made (if any) and close the user
interface.
Note If any invalid settings have been made, a warning message
Cancel Closes the user interface without saving.
Note If any changes were made, a warning message is displayed,
Help Launch context sensitive Help for the Active tab.
Save Evaluate changes and save them.
Action
will be displayed, allowing cancellation of the command.
allowing cancellation of the command.
Section 2-3
29