Connection - Omron PC CONNECTION - 04-1997 Operation Manual

Connection

2-2 Connection
Parts Required for Connection
2-4
The NT20S, NT600S and NT620S/NT620C have an RS-232C connector, while
the NT30/NT30C have an RS-232C connector and an RS-422A terminal block;
some computer link modules have an RS-232C connector and some have an
RS-422A terminal block. This section describes the methods for connection with
these connectors and terminal block.
Make cables that are suitable for the conditions of use, following the wiring details
given in this section.
The connectors, connector covers, crimp terminals, and recommended cables for
use with OMRON products are described here.
For details on the connectors, connector covers, and crimp terminals used at the
computer link module side, refer to the manual for the computer link module.
F Parts for RS-232C (Common to PT and NT-AL001)
Part
Connector
Connector cover
Cable
F Recommended Parts for RS-422A Terminal Block (for NT30/NT30C)
<Appropriate crimp terminals>
Fork type
6.2 mm or less
Part
Crimp terminal
(M3.5) (M3.5)
Cable
Model
XM2A-0901
DE-9P
XM2S-0911
DE-CI-J6
AWG285P
IFVV-SB
CO-MA-VV-SB
5P28AWG
Round type
6.2 mm or less
Model
2-YS3A
2-YAS3.5
2Y-3.5
2-3.5
V2-S3.5
2-3.5
H-9293A
(CO-HC-ESV-3P7/0.2)
Chapter 2-2
Remarks
9-pin type, made by OMRON
9-pin type, made by JAE
9-pin type, made by OMRON
9-pin type, made by JAE
Multi-core shielded cable, made
by Fujikura, Ltd
Multi-core shielded cable, made
by Hitachi Cable, Ltd
Remarks
Fork type, made by Japan Sold-
erless Terminal MFG
Fork type, made by Fuji Terminal
Fork type, made by Nichifu Ter-
minal
Round type, made by Japan
Solderless Terminal MFG
Round type, made by Fuji Termi-
nal
Round type, made by Nichifu
Terminal
Made by Hirakawa Hewtech
corp.