Function Restrictions Depending On The Support Tool - Omron NT20 User Manual

Function Restrictions Depending on the
Screens can be created for Host link, NT link, or C200H direct communications by using the conventional Sup-
port Tool indicated below.
In addition, the NT series Support Tool (Ver.2.@) can be used with Ver.4 of the direct connection function.
However, when the above Support Tool is used, restrictions apply to some functions as shown in the table
below.
The expressions used for the Support Tools In the table have the following meanings.
NT V2: NT Series Support Tool (Ver.2.@)
Support Tool NT Model
NT V2 NT20M
NT20S
NT20S
The NT20 cannot be used with combinations of Support Tools and settings other than those indicated above.
Reference: The RS-232C can be used in the same way with the NT series Support Tool (Ver.2.@). The
necessary Support Tool and "Tool Mode" (NT20 memory switch) settings in this case are as
follows:
NT Model: NT20S
Direct setting: No
Communications mode: Standard/High-speed
Tool Mode: NT20S
Appendix I
Support Tool
Direct Communications Mode
Connection
Ver. 4 Standard
Ver. 4 Standard/High-speed
Ver. 5 Standard/High-speed
Support Tool Restrictions
Mode
(NT20S memory
switch)
NT20M 250 screens max.,
Thumbwheel
numeral settings not
possible, no upper/
lower limits, hexa-
NT20S
decimal input not
possible, indirect
specification not pos-
sible, touch switch
input notification
fixed as "momen-
tary", data transmis-
sion in screen units
not possible.
NT20S No restriction
281