Muting; Muting Controller - Omron MS4800E - MANUAL 2 Operation Manual

!WARNING
!WARNING
!WARNING
!WARNING
!WARNING
!WARNING
!WARNING
12-1 Muting Controller RM-6
The muting and override functions disable the safety functions of the device.
You must ensure safety using other method when these functions are operat-
ing.
Install muting sensors so that they can distinguish between the object that is
being allowed to pass through the detection zone and a person. If the muting
function is activated by the detection of a person, it may result in serious
injury.
Muting lamps (external indicators) that indicate the state of the muting and
override functions must be installed where they are clearly visible to workers
from all the operating positions.
Muting related time must be properly configured for its application by a suffi-
ciently trained and qualified person, and the person must have responsibility
for settings, especially when setting the muting time limit to infinite.
Use independent 2 input devices for muting inputs.
You must install MS4800 system muting sensor, and physical barrier, and con-
figure time settings for muting so that an operator should not enter hazardous
zone.
Install the switch that activates the override in a location that provides a clear
view of the entire hazardous area and where it cannot be activated from within
the hazardous area. Make sure that nobody is in the hazardous area before
activating the override function.
Muting with the MS4800 system is available together with the Muting Control-
ler RM-6.
The MS4800 and an RM-6 offer a limited set of muting functions. The follow-
ing list describes the muting functions that can be achieved with the MS4800:
• 2 Sensor muting
• 50 ms sensor input filtering
• Mute bypass
+24 VDC = Enabled, 0 V or unconnected = Disabled)
• Mute timeout
+24 VDC = No Limit, 0 V or unconnected = 2 minute time option)
allowed (configurable
limit (configurable
SECTION 12

Muting

using sensor 4
using sensor 3
input,
input,
37