Precautions For Correct Use - Omron MS4800E - MANUAL 2 Operation Manual

Precautions for Correct Use

4 Precautions for Correct Use
4-1 Installation environment
4-2 Wiring and installation
4-3 Cleaning
4-4 Object detection
xviii
Observe the precautions described below to prevent operation failure, mal-
functions, or undesirable effects on product performance.
Do not install the MS4800 system in the following types of environments:
• Areas exposed to intense interference light, such as direct sunlight
• Areas with high humidity where condensation is likely to occur
• Areas where corrosive gases are present
• Areas exposed to vibration or shock levels higher than in the specification
provisions
• Areas where the product may come into contact with water
• Areas where the product may get wet with oil that can solve adhesive
Do not use radio equipment such as cellular phones, walkie-talkies, or trans-
ceivers near the MS4800 system.
• Make sure to perform wiring while the power supply is OFF. Otherwise,
the MS4800 system may fail to operate due to the diagnosis function.
• When replacing the cable connectors with other types of connectors, use
connectors that provide a proper grade of protection.
• Properly perform the wiring after confirming the signal names of all the
terminals.
• Do not operate the control system until 2 seconds or more (2,2 seconds
or more in case of series connection) after turning ON the power of the
MS4800 system.
• Be sure to route the MS4800 system cable separate from high-potential
power lines or through an exclusive conduit.
• When using a commercially available switching regulator power supply,
make sure to ground the FG terminal (frame ground terminal).
• Install the emitter and receiver so that their vertical direction should
match.
Do not use thinner, benzene, or acetone for cleaning, they affect the product's
resin parts and paint on the case.
The MS4800 system cannot detect transparent and/or translucent objects.
4