Options; One-Touch Mounting Plate; Heat Sinks; Mounting Bracket - Omron G3NA Manual

■ Options (Order Separately)

One-touch Mounting Plate

The One-touch Mounting Plate is used to mount the GN3A to a DIN
Track.
R99-12 FOR G3NA (for the G3NA and G3NE)
Two, M4 mounting
holes for the G3NE

Mounting Bracket

R99-11 (for the G3NA-240B-UTU, G3NA-250B-UTU, G3NA-450B-UTU)
Use Mounting Bracket R99-11 so that the G3NA-240B/-250B/-450B-UTU
can be mounted with the same pitch as that of the G3N-240B.
12.5
21

Heat Sinks

Y92B-N50 Heat Sink (for the G3NA-205B-UTU, G3NA-210B-UTU, G3NA-410B-UTU, G3NA-D210B-UTU)
For surface mounting, a 30% derating of the load current is required (from the Load Current vs. Ambient Temperature graphs).
The orientation indicated by the external dimensions is not the correct mounting orientation. When opening mounting holes, refer to the
mounting hole dimensions.
35
30.5±0.3
8
Solid State Relays
Two, M4 mounting
holes for the G3NA
30
44
16
8
5
4 4.6
4.6 dia. Two, M3 holes
Two, M4 holes
47.6
5.6
77 max.
90±0.3
100 max.
G3NA
To mount the Relay to DIN
Track, first mount it to the
One-touch Mounting Plate
and then attach it to the DIN
Track as shown in the
diagram.
To remove the Relay from
the DIN Track, pull down on
the tab with a screwdriver in
the direction of the arrow.
• When a Relay is mounted to DIN Track, use it within the rating for a
Relay without a heat sink.
• Use the following DIN Tracks: PFP-100N or PFP-100N2.
Two, 3.2-dia. holes
44 max.
30
47 max.
5
4.5
6
51 max.
56
Mounting Holes
Two, 4.4-dia.
or M4 holes
90±0.4
35±0.2
Weight: approx. 200 g