480-VAC models to allow use in a greater range of applications. A comprehensive lineup that now includes 480-VAC models. Slim design with 3-phase output and built-in heat sinks. New heat sink construction with smaller mounting section. DIN track mounting supported as standard. (Screw mounting is also possible.)
(60 Hz, 1 cycle) (60 Hz, 1 cycle) Permissible I 260 A 1,260 A (half 60-Hz wave) Note: Rated carry current varies depending on the ambient temperature. For details, refer to Load Current vs. Ambient T emperature in Engi - neering Data.
Page 3
3N-VD 2N-VD 3N-VD 2N-VD Operate time 1/2 of load power source cycle + 1 ms max. (DC input) Release time 1/2 of load power source cycle + 1 ms max. (DC input) Output ON voltage drop 1.6 V (RMS) max.
Page 4
3N-VD 2N-VD 3N-VD 2N-VD Operate time 1/2 of load power source cycle + 1 ms max. (DC input) Release time 1/2 of load power source cycle + 1 ms max. (DC input) Output ON voltage drop 1.8 V (RMS) max.
G3PB-245B-3N-VD G3PB-215B-3N-VD G3PB-515B-3N-VD G3PB-515B-2N-VD G3PB-235B-2N-VD G3PB-245B-2N-VD G3PB-215B-2N-VD G3PB-525B-3N-VD G3PB-525B-2N-VD G3PB-535B-3N-VD G3PB-545B-3N-VD G3PB-535B-2N-VD G3PB-545B-2N-VD Energized time (ms) Energized time (ms) Energized time (ms) Input Voltage vs. Input Current and Input Voltage vs. Input Impedance Input current Input impedance Input voltage (V)
Page 6
G3PB Common G3PB Common Dimensions Note: All units are in millimeters unless otherwise indicated. G3PB-215B-3N-VD G3PB-515B-3N-VD G3PB-215B-2N-VD G3PB-515B-2N-VD G3PB-225B-2N-VD G3PB-525B-2N-VD Without Terminal Cover With Terminal Cover Two, 4.6-dia. mounting holes Four, 8 dia. Two, M3.5 80.5 100 max. max. Two, R2.3...
Therefore it is necessary to test the G3PB under a variety of If the G3PB is provided with a terminal cover, be sure to attach conditions that are possible. As for the characteristics of the the terminal cover to the G3PB before operating the G3PB.
Tightening Torque dust) or salts. Refer to the following and be sure to tighten each screw of the Unit to Do not use or store in locations subject to shock or vibration. the specified torque in order to prevent the Unit from malfunctioning.
ALL DIMENSIONS SHOWN ARE IN MILLIMETERS. To convert millimeters into inches, multiply by 0.03937. To convert grams into ounces, multiply by 0.03527. Cat. No. J112-E1-2 In the interest of product improvement, specifications are subject to change without notice.