Maintenance Parts And Replacement; F150-Sl20A/Sl50A - Omron F150-3 - MANUAL 1 Setup Manual

Maintenance Parts and Replacement

7-1

Maintenance Parts and Replacement

Note
7-1-1

F150-SL20A/SL50A

Note Not possible to connect to the previous F150-S1 Camera.
Replacing the Lens or Light Source
Note Follow these steps in the reverse order to mount the Lens
60
Maintenance parts of the F150 are shown in the following
table.
1. The Light Source will gradually lose illumination if used for
long periods (approx. 20% loss after 1,500 hours of use).
Replace the Light Source after approx. 1,500 hours of use.
2. Replace the Light Source if it is partially damaged or not
fully functioning.
Part
20-mm Lens (20 mm × 20 mm)
50-mm Lens (50 mm × 50 mm)
Light Source
Camera base
Hold this section of the
Lens when removing.
1. Disconnect the light cable from the light connector on the
back of the Camera.
2. Remove the light cable from the slot in the camera base.
3. Remove the two screws securing the Light Source.
4. Remove the Light Source from the Camera.
5. Remove the Lens from the camera mount.
and Light Source.
Model No.
F150-LE20
F150-LE50
F150-LT10A
Hold this section when
removing the Cable.
Light source Camera cable
connector connector
Section 7-1