Cables; Camera - Omron F150-3 - MANUAL 1 Setup Manual

Installation Precautions
F150-C10E-3-DRT (CompoBus/D Model)
1-1-4

Cables

1-1-5

Camera

4
2. Do not install the F150 components within 200 mm of pow-
er cables.
Power cable
200 mm min.
1. Since the product is defined as built-in type, install the
product inside the control panel.
2. Do not apply external forces exceeding 50 N to Compo-
Bus/D connectors. When wiring communications cables,
remove the connectors from the F150.
3. Before setting the DIP switch or connecting cables, turn
OFF the Programmable Controller, F150, and the commu-
nications power supply.
4. Observe the following precautions when wiring communi-
cations cables.
a) Separate communications cables from power lines or
high-tension lines.
b) Do not bend communications cables.
c) Do not pull on communications cables with excessive
force.
d) Do not place heavy objects on communications ca-
bles.
e) Be sure to route communications cables within ducts.
Always turn OFF the power before connecting or disconnect-
ing cables.
The Camera's case is connected to the 0V line in the internal
circuits. Heed the following precautions to prevent noise inter-
ference.
1. Do not ground the Camera.
2. Do not remove the base attached to the Camera.
200 mm min.
Section 1-1