Omron E5CK User Manual page 178

PARAMETER OPERATIONS LIST
Level 0
PV/Present SP
Pattern No.
Step No. monitor
Hold
Advance
Standby time monitor
Pattern elapsing time monitor
Pattern execution count monitor
MV monitor (heat)
MV monitor (cool)
Power ON
1 second min.
Level 0
1 second min.
Program
1 second min.
Level 1
1 second min.
Level 2
1 second min.
Setup mode
1 second min.
Expansion
mode
1 second min.
Option mode
1 second min.
Calibration
mode
Program
Pattern No.
Number of steps
to
Step 0 to 7 SP
to
Ramp rate 0 to 7
to Step 0 to 7 time
to
Step 8 to 15 SP
to
Step 8 to 15 time
Pattern execution count
Alarm value 1
Alarm value 2
Alarm value 3
Time signal 1 enabled step
Time signal 1 ON time
Time signal 1 OFF time
Time signal 2 enabled step
Time signal 2 ON time
Time signal 2 OFF time
PARAMETER OPERATIONS LIST
+
1 second min.
Manual mode
1 second min.
+
RUN/RST RUN/RST
1 second min. 1 second min.
Protect mode
+
RUN/RST
1 second min.
Parameters in a mode can be
switched by the
eter following the last parameter is the
top parameter of the mode.
Level 1
AT Execute/Cancel
Proportional band
*1 Integral time
*1 Derivative time
Cooling coefficient
Dead band
Position-proportional dead band
Manual reset value
Hysteresis (heat)
Hysteresis (cool)
Control period (heat)
Control period (cool)
*1
In the rate of rise setting, Target SP 0
to 7 and Soak time 0 to 7.
+
key. The param-
A–11